Search results

Ever-tightening regulations on fuel economy and carbon emissions demand continual innovation in finding ways for reducing vehicle mass. Classical methods for computational mass reduction include sizing, shape and topology ...

The use of injection moulded, short fibre reinforced structural parts in vehicle design is increasing due to their low density and outstanding mechanical properties. As the distribution and orientation of fibres within the components ...

A pilot study has been done at Volvo Cars Corporation (VCC) to explore the potential of Digimat as material model for car components made of short fiber reinforced thermoplastics. It has been a joint project between Safety and ...

Starting per January 2015 Euro NCAP requires use of the HIII-5th percentile small female for its full width frontal barrier test procedures. The dummy should be according to the latest agreed FTSS / Denton brand harmonization and ...

The paper describes parts of the joint research project Swim-RTM including several industrial and academic partners. Its goal is to combine LS-DYNA and the open-source fluid-dynamics solver OpenFOAM® to simulate the production process ...

Developments on the THOR dummy over the past years resulted in the THOR-M version which is foreseen for introduction into regulatory and Consumer tests in the 2020 timeframe. NHTSA considers to use the THOR-M dummy in an angled impact ...

The correct modeling of the sheet forming of fabric reinforced thermoplastic composites, so called organosheets, is still a challenge. In the past it was possible to predict accurately and efficiently the fiber orientation during the ...

The primary focus of this paper is on FE modeling and simulations performed to capture the material behaviors during a textile preform and a thermoplastic pre-preg forming manufacturing using LS-DYNA. Although an out-of-plane bending ...

Paperboard is widely used as a package material for food and beverage. The ability to simulate the forming of the packages is of great interest, due to the variety in shapes and paperboard material structure combined with production ...

Crash Investigation in CAE has become more cost-efficient and bio-fidelic with the increasing use of Human body models. With the increasing emphasis on integrated safety, it is necessary to find a methodology to use these HBMs for ...